Fagor FDD24, Service Manual

Page: 13 / 29

BAR EQUIPAMENT OPERATIOS AND SERVICE MANUAL
CAUTION: Handle all pressure system components with care. Do
not use excessive pressures. Be sure instructions are understood
thoroughly, If in doubt, contact your dealer/distributor for
explanation.
TAPPING INSTRUCTIONS
This cooler will accept only the quarter-size keg. The Sankey type is the
most modern and easiest of all to tap with the available taps. The type
keg and tap ypu use will depend on the brand of beer your purchase.
Your beer distributor can provide additional instructions and tips on how
to maintain the beer to your satisfaction.
Following these tapping instructions, place the keg in front of cabinet for
tapping. After all connections are complete and checked for leaks,
place the CO2 bottle in the rear (inside) of cabinet with the pressure
gage visible for reading, then place the keg in position, allowing the
door to be closed completely without interference.
Make certain that beer line and keg are not touching the evaporator.
How to Tap a Keg of Beer
Sankey Type Barrel
1. Connect line from pressure
source to tap nipple (use clamp).
Using coupling washer connect
beer line to thread on probe. Holding
flats on probe with wrench, tighten
wing nut or hex nut on beer hose.
2. Align tap with lugs in barrel,
insert tap.
3. Turn tap body handle ¼ turn
clockwise until tight to secure
tap to barrel. Turn on pressure
regulator.
4. Rotate wheel handle ¼ turn clockwise.
Be certain handle is turned as far as it
will go to stop. This will assure that the
beer and gas pots in the keg down tube
will be fully opened.
To Beer Faucet
BARREL IS TAPPED
To Pressure Source