Chapter 4 - page 3
MCO-TCO work mode
4.2 SEE CONTENT OF A PROGRAM
To see the content of a part-program, select this with the pointer from the left-hand column. To do
this use
and
.
The right -hand column will display the cycles which said part consists of:
If you press
or
or
the pointer goes on to the right-hand column.
Now keys
and
let the pointer be moved over the blocks or cycles which make up the part.
To sum up, use keys:
and
to move up and down in each one of the columns
and
to change the column
After selecting an operation, the CNC allows:
Seeing the operation in detail
Erasing the operation
Moving the operation to another position
Modifying the operation
4.2.1 SEEING ONE OF THE CYCLES IN DETAIL
After selecting the operation required, with the pointer, press
The CNC will extract all the stored data and will display them on the corresponding cycle screen.
Once there, it is possible to:
Simulate the operation. (See next the chapter on "Execution and Simulation").
Execute the operation. (See next the chapter on "Execution and Simulation").
Modify the operation
Store the operation again replacing the previous one or including it as a new one.
