Fagor 8055 M, Programming Manual

Page: 325 / 482

Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
·325·
PROBE
9. Boss m
e
asuring c
ycle
9. Fourth probing movement.
Same as above.
10. Withdrawal movement.
This movement consists of:
·1· Withdrawal to the fourth approach point.
·2· Movement of the probe in rapid (G00) and at a distance (B) above the boss to the real center
(calculated) of the boss.
·3· Should (C0) be programmed, the probe will be moved to the point where the cycle was called.
Movement along the longitudinal axis to the coordinate of the point (along this axis) from
where the cycle was called.
Movement in the main work plane to the point where the cycle is called.
Arithmetic parameters modified by the cycle
Once the cycle has been completed, the CNC will return the real values obtained after
measurement, in the following global arithmetic parameters.
P294 Boss diameter.
P295 Boss diameter error. Difference between the real diameter and programmed
diameter.
P296 Real coordinate of the center along the abscissa axis.
P297 Real center coordinate along the ordinate axis.
P298 Error detected along the abscissa axis. Difference between the real coordinate of the
center and the programmed theoretical coordinate.
P299 Error detected along the ordinate axis. Difference between the real coordinate of the
center and the programmed theoretical coordinate.