!
During this operation, the gate moves very slowly at the minimum speed rate as factory pre-set.
- Press and hold the button (or give an Open command): the automation operates to Open on deadman control mode.
- Let the gate travel to the limit switch Open, release the button and press
ENTER
to confirm. (To reduce the gate travel on to the Open limit switch, should the gate
over travel the limit position, press the button and then confirm).
NOTE WELL
:
- Should the gate run into an obstacle ( eg. stones, etc. ...) during the open or close cycles, the automation stops on expiring of the pre-set time. Any new
command will reverse the gate motion to the next limit switch, at the minimum speed as factory pre-set. The subsequent operations are carried on following
the settings that are pre-set during the installation.
- After a power failure, when the board is powered back with voltage supply, the automation carries on the first operation at the minimum speed as factory
pre-set, provided that none of the limit switches is engaged. No memorizing is required. All previous settings are retained.
11
Function Automatic-Semiautomatic
- Deadman control
DISPLAY
SCREEN 5
DISPLAY
SCREEN 6
mode of use................
Automatic
Ø
Ø.ØHz Ø sp
door Closed! ....
Button
ENTER
, to enter the function
Button
, to select the operating mode
Ø = Automatic
, on an opening comand impulse, the gate Opens, stops for a pre-set Dwell time (see screen 7),
when its expired It closes automatically.
1 = Semiautomatic
, on an opening command impulse the gate opens and stays open. A closing command
impulse is needed to close it.
2 = Deadman control
, Open and Close operations are by hold on switched control (no relay self-holding is
involved). The automation is to be attended and the command unit is required to be held switched to achieve
gate operation. Any operation is stopped on releasing the button or key.
Once selected the mode press
ENTER
to confirm
radio:
REVERSES
Ø
Radio function
Button
ENTER
to enter the function
Button
to select the operating mode:
0 = Radio reverses on opening
1 = Radio step-by-step with intermediate Stop
2 = Radio doesnt reverse on opening
Once selected the mode press the
ENTER
button to confirm
Status of the automation
It is visualized the status of the automation when power is supplied: door in stop (closed) position.
DISPLAY
SCREEN 4
Memorizing
the gate travel
Once all the electrical connections are completed, with the
gate in closed position
(limit switch Close engaged) make sure the
electric motor turns in the correct direction in relation to the limit switches. During this phase, it is advisable to set the torque
at a suitable rating to prevent the clutch from slipping while the unit is learning ie storing this setting (a high rating is advisable).
SCREEN 4.1
RESET
ENTER
RESET
ENTER
Max course quote
Ø
1ØØØ
DISPLAY
RESET
ENTER
RESET
ENTER
RESET
ENTER
7
3
COMMON
RADIO
Drwg. No.
4534
GB
220
THREE-PHASE
THREE-PHASE FOR AUTOMATIONS WITH
HEAVY SLIDING GATES - DIGITAL PROGRAMMING
®
