Setup mode
The setup mode allows selection of setups and routings. Further you can copy and fill setups and parts,
reset setups (factory reset) and send/receive setup data as sysex (backup/restore).
Start and leave setup mode by holding down red shift key and press blue key. The activated setup mode
is indicated by blinking yellow setup-LED.
To start any special, copy, paste, reset, send or receive function please hold down the button 3 to 8 while
running bar lines shown in the display.
Setup and routing selection (buttons 1 and 2) take effect at once.
Hold down the red shift key and turn the encoder to send Midi commands in setup mode. Pots always
send Midi commands in setup mode.
Setup (Button 1)
SE01
....
30
select setup 1 to 30
Routing (Button 2)
Push encoder to select the Midi-out-port (blinking display digit) and turn encoder to rout any of the 4
possible Midi-in-ports to that Midi-Out-port. Each Out-port can be routed to one In-Port separately.
Each display digit represents one Midi-out-port described below the display.
Press the blue key to switch between two independent routing ways:
1.
display points are off = routing of all midi data except system realtime commands
2.
display points are lit = routing only of system realtime commands (midi clock, start, stop, continue)
Routing means that the incoming data will be merged to the controller data.
All routings are global (same for all setups) and will be stored automatically by leaving setup mode.
n
no routing to that out-port
1
routing to Midi 1 in-port
2
routing to Midi 2 in-port
U
routing to USB in-port
E
routing to Extension in-port
Special (Button 3)
duc1
duplicate all controls of column 1 (left column) to columns 2 to 12 (12 track mode)
duc2
duplicate all controls of columns 1/2 to 3/4, 5/6, 7/8, 9/10 and 11/12 (6 track mode)
duc3
duplicate all controls of columns 1/2/3 to 4/5/6, 7/8/9 and 10/11/12 (4 track mode)
duc4
duplicate all controls of columns 1/2/3/4 to 5/6/7/8 and 9/10/11/12 (3 track mode)
durP
duplicate all pots of row A to row B
durb
duplicate all buttons of row C to row D
Summary of Contents for MX 12
Page 1: ...Faderfox NEW MODULE MX12 User manual...
Page 6: ......
