Foundation 2 no. pads
200 x 200 x 700mm in
C20 concrete
(recommendation only)
M10 x 75mm sleeve
anchor into 12mm hole
in foundation with
anti-vandal armour ring
7
5
12
410 Ctrs
8
9
0
1760 Ctrs
4
5
0
Ground Level
1800
545
Foundation 2 no. pads
200 x 200 x 700mm in C20
concrete (recommendation only)
410 Ctrs
4
5
0
545
8
9
0
540 Ctrs
580
Ground Level
Foundation 2 no. pads
200 x 200 x 700mm
in C20 concrete
(recommendation only)
Installation Instructions
ALL INSTALLATION WORKS TO BE CARRIED OUT BY COMPETENT PERSONNEL - INSTALL AS COMPLETE UNIT
Seat (Surface Fix)
Chair (Surface Fix)
Util Seat / Chair -
(surface fix option)
1. Install suitable foundation pads (see illustration) each with top face at ground level
2. Position bench in correct orientation with bases centrally on foundation pads;
then mark hole positions through fixing lugs
3. Remove the bench; drill holes Ø12mm x 75mm deep (or as bolt manufacturer’s
recommendations)
4. Clear debris from holes
5. Reposition bench unit and fix to foundation pads using 4 no. zinc-coated M10 x
75mm sleeve anchors tightened to 50Nm (or as per manufacturer’s instruction).
Ensure bench remains level during fixing process. Finally hammer an anti-vandal
armour ring over
each bolt head to prevent tampering
6. Check level
IMPORTANT NOTE:
Ensure that stainless steel is protected during site cutting of stone – contamination from disc cutters will
produce corrosion on stainless steel components.
5
UTIL SEAT/CHAIR installation
