www.factorelectronics.com
V-66-KP (keypad) INSTALLATION INSTRUCTIONS
IMPORTANT:
The V-66-KP (keypad) should be mounted in an electrical box or in-wall mud ring using a screwdriver to tighten.
Do not use a power drill to tighten the keypad screws. Over tightening can damage the keypad.
INSTALLATION:
Connecting the V-66-KP (keypads)
Use a good quality Cat5e/6 cable and crimp RJ45 jacks on each end of the cables.
The RJ45 jack plugs into the back panel of the keypads and the 6 x RJ45 jacks on the back panel of the V-66-Keypad-Hub.
The V-66-Keypad-Hub is included in your V-66 kit. Plug the RJ45 jacks into any available jack on the V-66-Keypad-Hub.
Zone assignment is determined by the MODE dip switches on the back of the V-66-KP (keypad).
Included V-66-Keypad-Hub
NOTE:
Keep the hub close
to the V-66 controller
Cat5e/6
2-4 meters
Cat5e/6 200+ meters
Cat5e/6 200+ meters
Cat5e/6 200 + meters
Cat5e/6 200 + meters
Cat5e/6 200 + meters
Cat5e/6
