Page
19
with
28
Page
19
with
28
Page
19
with
28
Page
19
with
28
MANUAL - KRAMER BI-pulse MIG / MAG 200
fan to cool the welding machine. Exclusion of the lamp indicates the temperature drop to a normal level. You can take
further work.
ATTENTION !
When welding components which form an integral part of the vehicle it is essential to disconnect the battery or use
special protection. Otherwise, the electronic parts of the vehicle can be permanently damaged. When welding to
connect the handle mass close as possible to the weld site.
D. MAINTENANCE
D. MAINTENANCE
Regularly remove dust with clean compressed air. If the unit is in working conditions in the smoke, in the heavily
polluted air every day remove accumulated dust.
Air pressure should be maintained at a level not to damage the small components inside the machine max. 2-4 bar.
Inspect the internal welder circuits, check the accuracy and reliability of connections (in particular equipment and
parts). In the case of notice of rust and loosening of the connection remove rust and oxide coating with abrasive
paper, and re-connect securely. Avoid situations where water or steam could get into the device. In the case of
welding moisture should dry it, and then check the insulation of the device (also between calls and contacts). After
checking that everything is in order, you can continue working.
Summary of Contents for KRAMER 200
Page 1: ......
