Page
12
with
28
Page
12
with
28
Page
12
with
28
Page
12
with
28
MANUAL - KRAMER BI-pulse MIG / MAG 200
Before starting the welding electrode attach the clamp holder. Arc ignition, rubbing the tip of the welding electrode,
and then slightly raise the height of the holder usually used in welding.
To facilitate arc ignition, welding machine equipped with factory hot start function (hot-start), which is to increase the current
at the beginning of welding. During welding, the electrode metal core is gradually melted and deposited at the welded
component in the form of droplets, and evaporating the sheath into a gas shielding. In order to increase liquidity of the
welding arc, during the detachment of the metal droplet, when it can cause short circuits between the electrode and puddle,
followed by a temporary increase in the welding current (ARC-force), which prevents extinction of the arc. When welding with
coated electrodes at each pass should be removed from weld slag.
8. Control Description:
8. Control Description:
AND
- knob welding current [Amps], a test wire (after pressing) and the choice of the welding parameters in the MENU mode (see Table
AND
- knob welding current [Amps], a test wire (after pressing) and the choice of the welding parameters in the MENU mode (see Table
menu of welding parameters).
V
- knob welding voltage [volt], the test gas (after pressing) and the choice of the welding parameters in the MENU mode (see Table menu of
V
- knob welding voltage [volt], the test gas (after pressing) and the choice of the welding parameters in the MENU mode (see Table menu of
welding parameters).
1. Mode synergic MIG / MAG (increase
1. Mode synergic MIG / MAG (increase
welding current results in an automatic increase
voltage,
and
wire feed speed).
2. MIG / MAG welding with a single pulse
2. MIG / MAG welding with a single pulse
3. MIG / MAG double pulse
3. MIG / MAG double pulse
4.
MMA electrode welding or TIG-LIFT tungsten electrode.
Summary of Contents for KRAMER 200
Page 1: ......
