Fac F 250 E, Use And Maintenance Manual

Page: 30 / 80

28
EN
USING THE MACHINE
5
.1 - Loading the product on the
tray
• Check that the slice thickness control
knob (6) is correctly placed on “ 0 ”.
• Draw the tray back completely (towards
the operator) to loading position.
• Lift the product grip (10) by pulling it
away by 10 cm from the blade and put
it in rest position.
• Lay the product to be sliced on the tray
(8) against the wall on the operator
side;
• Secure by means of the product grip
(10) by exerting a slight pressure; such
as to not allow the product to move
during the cutting operation.
Fig. 6
5
.2 - Slicing the products
• Adjust the slice thickness with the knob
(6).
• Start the blade by pressing on the
green button “I” (3a) or by turning the
switch (3b) clockwise on “
I/ON ” (the
indicator “5” turns on).
• Grip the handle (15) fixed to the tray
(8) and start the forward and backward
cutting movement.
• At the end of the cutting operations move
the slice thickness control knob (6) back
to “
0 ” and draw the tray (8) back.
• Stop the blade movement by pressing
the red button “
0
” (4) or by turning the
switch (3b) anticlockwise on “
0/OFF
”;
the warning light (5) turns off.
4
5
5
3a
3b
6
10
15
8
29
EN
16
20
6
9
Fig. 7
6
.1 - Components disassembly
• Disconnect the plug from the mains
power supply.
• Move the gauge plate control knob (6)
to “ 0 ”.
• Remove the various components as
described in the following paragraphs.
• Fully unscrew (anticlockwise direction
of rotation) the blade plate tie-rod (16).
• If the blade plate (9) is blocked, apply
pressure on the tie-rod knob (16) to
move it.
• Remove the tie rod (16) and remove
the blade plate.
• Remove the slice guard (20) by
unscrewing the two fixing screws.
CLEANING THE SLICER
• When the processing is over, remove the waste residuals from the collector surface (19).
The machines must be accurately cleaned after use. After a shorter or
longer period of inactivity clean the slicer before use.
WARNING: Cutting hazard!
Use protective cut- and tear-resistant gloves and perform
all operations with extreme care.