21.
Install the passenger cable body bracket with factory
hardware back into the factory location. Carefully bend the
bracket just enough for the cable to clear floor pan. SEE
PHOTO BELOW
22.
Connect the cables back into the adjuster and set back at
original setting
(refer to earlier measurement of threads
above the adjuster nut).
If additional adjustments are
required, refer to owners manual for proper procedure
SEE
PHOTO BELOW.
23.
Locate the FT50258 Traction Bar Crossmember. Remove
the C-Lock nuts from the front bolts on the leaf springs and
pull the bolts out just so that the end of the bolt is flush
with the spring mount. Place the crossmember up to the
spring mounts
(main bar of the crossmember will mount
in front of the leaf springs)
and re-install the bolts and
hardware. (leave loose). SEE PHOTOS IN NEXT
COLUMN.
24.
Locate FT50256 (driver) and FT50257 (pass.)
Crossmember frame brackets and supplied ½” x 4 ½” bolts
and hardware. Place the brackets on the crossmembers so
the angled face of the bracket is facing forward on the truck
and install the hardware (leave loose). Rotate the
crossmember with the brackets up onto the frame until the
bottom of the bracket is flush with the bottom of the frame.
Using a paint pen or punch, mark the holes of the brackets
onto the frame. Swing the crossmember and brackets down
from the frame. SEE PHOTOS AND DIAGRAMS ON
NEXT PAGE
