Version 05/08 - Page 9
FOR ALL INSTALLATIONS
1.
Install the grease filters using two hands by first pulling and
turning the knob to the left so that the locking lever does not
protrude from the filter
(as in FIGURE 12)
. Insert the opposite
end of the filter into the retaining channel. Insert the knob end
next, then turn knob to the right to lock the filter into place.
Rangehood Control Panel
The control panel is located on the front edge of the rangehood
canopy. The position and function of each control button are
indicated in
FIGURE 13
.
Light On/Off Button ( L )
On/Off switch for the halogen lights. Push the button in to turn
the light ON, push again to turn the light OFF.
Blower
On/Off and Speed Buttons ( 1, 2, 3 )
Push button (1) to turn ON and OFF the blower. This button
must be pushed in for the blower to operate regardless of
speed chosen. Button (1) operates the blower on LOW
speed. Push button (2) for MEDIUM speed. Push button (3)
for HIGH speed.
Cleaning
The stainless steel grease filters should be cleaned frequently in
hot detergent solution or washed in the dishwasher. Stainless
steel cleaner should be used on stainless rangehoods.
Abrasives and scouring agents can scratch stainless steel
finishes and should not be used to clean finished surfaces.
Replacing the Lamps
Before attempting to replace the lamps, make sure that the
light switch is turned off. Remove the 2 screws
(as indicated
in FIGURE 14)
that hold the light support and gently pull the
support down from the hood. Remove the lamp from the light
support and replace with new lamp. Replace the light support
and fix it into place with the 2 screws.
An alternative method to replace the lamps is to use a 1
1/4" suction cup (
FIGURE 15
). Attach the suction cup to
the bulb and pull firmly down on the bulb and replace with
a new lamp.
FIGURE 12
2.
Turn the power supply on. Turn on blower and lights. If the
rangehood does not operate, check that the circuit breaker is not
tripped or the house fuse blown. If the unit still does not operate,
disconnect the power supply and check that the wiring connec
-
tions have been made properly.
FIGURE 13
FIGURE 14
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
For Best Results
Start the rangehood several minutes before cooking to develop proper
airflow. Allow the unit to operate for several minutes after cooking is
complete to clear all smoke and odors from the kitchen.
Blower Indicator
Light ( I )
Lights up to indicate
blower is ON.
FIGURE 15
WIRING DIAGRAM
• This rangehood uses 20 watt MR-11 halogen lamps w/ cover.
