Faber Respect Premium OC, Installation Manual

Page: 12 / 32

Installation manual Respect Premium OC
12 < < < <
4.7 Installing the flue pipes
Install the flue pipes according to the installation
manual supplied with the appliance (40011968)!

The distance to combustible materials
must be min. 50mm, calculated from the
outside of the flue pipe.

Never start immediately with length-
adjustable concentric flue pipe on the
appliance.

Horizontal sections should be installed to
allow a slope towards the appliance
(3 degrees).

Build the system from the appliance. If
this is not possible you can make use of an
extendable adapter section.

For fitting of the flue system, the 0,5m
length-adjustable pipe must be used.
Make sure that the inner pipe is always
15mm longer than the outer pipe. Wall-
and roof terminal can also be cut. These
components must be secured with a self-
tapping screw.
4.8 Constructing the false chimney
Before positioning the false chimney, we advise to
perform a functional test with the fireplace as
defined in chapter 7 “Checking the installation”.
False chimney

Construct the false chimney of non-
combustible material in combination with
metal profiles or of masonry/concrete
blocks.

Always use a lintel or reinforcing bars
while bricking the false chimney. They
should not be placed directly on the
fireplace.

Make sure that the fireplace never
functions as a load-bearing construction,
because of the expansion of the fireplace
through warmth.
Ventilation
Correct ventilation prevents damaging overheating
of the gas control block and its electronics and also
limits the temperature of the convection air. Use
the (optional) supplied Faber ventilation grids
(article number A9296400) or a similar alternative
with a minimum free passage of 200cm² per grid,
in the space above the fire, when building the false
chimney. Within the false chimney, an horizontal
screen plate, made of non-combustible material,
must be installed just above the ventilation
openings. (see fig. 1.0-A).
5 Installing glass

Please note!
Before installing the front glasses, install the
side glasses first!
5.1 Side glasses
For cleaning only it’s not necessary to remove the
side glass.

Place a suction cup on the side glass.

Lower the side glass into the space behind
the build-in frame (fig. 3.1).

Hold the glass tilted at an angle and insert
the glass into the upper glass groove (fig.
3.2).

Now lower the side glass into the lower
glass groove.
For removing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
5.2 Front glasses

Please note!

First install the side glasses (see chapter
5.1).

First install the right front glass (with
Faber logo).

The white stopper in the glass groove on
the right corner holds the right front glass
in place (see fig. 3.5).
Front glass right (with Faber logo):

Place the suction cups on the front glass.

Insert the front glass into the upper glass
groove and lower the glass into the lower
glass groove (see fig. 3.3).
Front glass left:

Place the suction cups on the front glass.

Insert the front glass into the upper glass
groove and lower the glass into the lower
glass groove (see fig. 3.4).

Check whether all the glasses at the
corners are properly aligned.
For removing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.