Faber Respect Premium OC, Installation Manual

Page: 11 / 32

Installation manual Respect Premium OC
11 < < < <
We advise using a gas connection directly from the
gas meter to the appliance, with a shut-off valve in
the proximity of the appliance, which must always
be freely accessible. Position the gas connection so
that it is easily accessible for service and the
burner unit can be disassembled at any time.
4.2 Electrical connection
Install a 230VAC/50Hz wall socket near the
fireplace for connecting the control unit.
See fig. 2.0 for the wiring diagram:
A= Adapter (6V)
B = Gas valve
C = Receiver
D = Ignition pin
E = Solenoid valve
F = 2nd thermocouple
See fig. 2.1 for the wiring diagram with I.T.C
(optional):
A= Adapter (6V)
B = Gas valve
C = Receiver
D = Ignition pin
E = Solenoid valve
F = 2nd thermocouple
G = I.T.C. (Intelligent Technical Controller)
4.3 Smart Home installation

Please note
This is only possible if the fire is equipped
with I.T.C!
The controller can be connected to an external
source, such as a Domotica system, by using a
Faber Interface Unit (article number A9323000).
4.4 Preparing the fireplace

Remove the fireplace from its packaging.
Ensure that the gas supply pipes under
the appliance are not damaged.

Remove the glass and any mouldings,
store them at a safe place and remove the
packaged parts from the fireplace.

Prepare the gas connection on the gas
valve.
4.5 Transporting the fireplace
If necessary the upper parts of the appliance can
be temporary be removed from the appliance. This
gives the appliance a minimum height of 780mm.
With the upper part removed, the appliance can be
transported on its back (fig. 1.4).

Please note!
The transport plate may only be removed
after the fireplace has been fixed to the wall
(see fig. 1.8).
4.6 Positioning the fireplace
Take into account the installation requirements
(see chapter 3). Place the fireplace at the right
place and level it (see fig. 1.9-D).
Rough height adjustment:

With the adjustable legs.
Accurate height adjustment:

With the adjustable feet.

Please note!

It is important that the appliance is
levelled, otherwise there is a chance that
the glasses on the corners do not fit well
together.

The appliance should always be fixed to
the wall, by using the fixation brackets
(see fig. 1.7).

The transport plate may only be removed
after the fireplace has been fixed to the
wall (see fig. 1.8).
Hanging on the wall
The fireplace can also be mounted on the wall by
using the supplied wall brackets (see fig. 1.5).

Please note!

Check the load-bearing capacity of the
wall. The device weighs approximately
200kg.

The transport plate may only be removed
after the fireplace has been fixed to the
wall (see fig. 1.8).

Determine the height of the appliance and
mount the wall brackets (see fig. 1.5).

Hang the appliance in the wall brackets.

Level the appliance with the set screws
(see fig. 1.6).

Fix the appliance to the wall with the 4
mounting brackets (see fig. 1.7).

Perform a final check. Check if the
appliance is aligned and levelled!

Remove the transport plate (see fig. 1.8).
Before proceeding with the installation, place all
glasses in the appliance to check the squareness
(see chapter 5). If the appliance is correctly
installed, the glasses will fit well together.