11
or the partially reflective glass falls out of the unit. (Fig-
ure 5)
7. Gently lift the partially reflective glass out of the unit
and set it aside in a safe place.
CAUTION:
Partially Reflective Glass is not tempered.
Do not bump or drop the Partially Reflective Glass to avoid
breakage and personal injury.
8. Proceed to the instructions within this manual relating
to the repair being performed - see Table of Contents
for page number.
MAIN CONTROL BOARD
REPLACEMENT
WARNING:
Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION:
If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required:
Phillips head screwdriver
CAUTION:
Follow “Preparation for Service” instructions
before proceeding.
1. Locate the main control board. (Figure 6)
2. Transfer the connections from the old board to the new
board.
3. Remove the board, by removing the screw on each
corner.
4. Install the new board onto the unit.
5. Ensure that all cords are replaced in the same manner
as prior to the service.
6. Reassemble in the reverse order as above.
LED POWER DISTRIBUTOR
REPLACEMENT (ONLY
NIGHT19/25)
WARNING:
Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION:
If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required:
Phillips head screwdriver
CAUTION:
Follow “Preparation for Service” instructions
before proceeding.
1. Locate the power distributor. (Figure 6)
2. Transfer the connections from the old board to the new
board.
3. Remove the board, by removing the screw on each
end.
4. Install the new board onto the unit.
5. Ensure that all cords are replaced in the same manner
as prior to the service.
6. Reassemble in the reverse order as above.
Figure 6
Flame Panel
Capacative Controls
and Display
Flicker Motor
Main Control
Board
Power Supply
NIGHT 13
NIGHT19/25
LED Power
Distributor
POWER SUPPLY REPLACEMENT
WARNING:
Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION:
If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required:
Phillips head screwdriver
CAUTION:
Follow “Preparation for Service” instructions
before proceeding.
1. Locate the power supply. (Figure 6)
