Faber Matrix FMG3326F, Instruction Manual

Page: 31 / 78

31 FaberFires.com
Unit Installation with Horizontal Termination
5 x 8 venting (Rigid Vent Systems)
Minimum Vent Clearances to Combustibles
Horizontal Top*
Horizontal Side
Horizontal Bottom
Vertical Vent
* Clearances noted must be maintained except when
Recommended Framed Opening Size
Vent Size Framing Size
lnstall the vent system according to the manufacturer’s instructions included with the components.
1. Set the unit in its desired location. Check to determine if wall studs or roof rafters are in the way when the venting
2.
3.
bead of Mill-Pac inside the outer section of the adaptor and a bead of Mill-Pac on the inner collar. Slip the adaptor
adaptor is typically factory installed.
4.
through the top and side nailing strips.
5. Assemble the desired combination of pipes and elbows to the appliance
adaptor and twist-lock for a solid connection.
!
For best results and optimum performance with each
result in drafting or performance issues not covered under warranty.
!
Hori
Wall straps are available for this purpose.
6.
the centerline of the horizontal pipe. Cut and frame the square hole in the exterior wall where the vent will be
terminated. See diagram 2 for center line requirements.
Female
Locking
Lugs
Male
Locking
Lugs
Diagram 1