Faber MatriX 1050/500 II, Installation Manual

Page: 13 / 44

Installation manual MatriX 1050/500 I,II,III 2 and MatriX 1050/650 I,II,III 2
13 < < < <
5.2 Side glass
For cleaning only it’s not necessary to remove the
side glass.
MatriX II and III:

Disassemble the front glass (section 5.1).

Disassemble the glass strip at the top
(fig. 3.6 and 3.7).

Place a suction cup and disassemble the
side glass (fig. 3.8).
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
6 Placing decoration material
It is not permitted to use other or to add more
material in the combustion chamber.
See the supplied decoration instruction card or
chapter 17:

Divide the glass granulate “A” on the
bottom only (fig. 17.1). Avoid a double
layer!

Place the log set.
o
Place the 2 large logs (fig. 17.2a).
Maintain space under the logs
(fig. 17.2b and c).
o
Place the log nearby the ignition
(Pay attention to the pin-hole
connection (fig. 17.3).
o
Place the remaining logs (fig. 17.4
till 17.5).

Divide the black and grey chips "B" around
the burner.

Keep ignition- and ionization pen free from
chips.
o
Make sure there is no contact
with the overlying log and the
burner itself (fig. 17.2d).

Start the fireplace as described in the user
manual.

Assess whether the flame distribution and
if present, the Symbio effect (glow bed), is
good. Move or remove any chips/glass
granulate to create a nice glow bed.

Install the front glass and check the fire
image.
7 Checking the installation
Checking for gas leaks
Check with a gas leak finder all connections and
pipes for gas leakage.
Check primary pressure
Check if the primary pressure correspond to the
data on the rating plate.
Measuring the primary pressure:

Close the shutoff valve. Turn the
measuring nipple “E” (fig. 1.3) a few turns
to open and connect a measuring hose to
the gas regulator.

Take this measurement when the fireplace
runs at high and low settings.

Do not connect the unit if the pressure is
deviates (+20% and -20%).

Please note!
Close the pressure measuring nipple and check
for gas leakage.
Check ignition and burner
Ignite the fireplace by using the remote control as
described in the user manual and test all burner
possibilities.
Now repeat the above check by using the APP. (App
set to Dealer level).
Check:

the Actual measured values;

the Diagnosis messages.
7.1 Checking the flame image
Let the fireplace burn for at least 20 minutes at
highest setting and check the flame for:

flame distribution;

colour of the flames.
If one or both points are not acceptable then check:

The position of the logs and/or the amount
of chips/glass granulates.

The pipe connections for leaks.
(in case of blue flames);

That the correct flue restrictor is fitted (see
fig. 1.6-F);

The outlet:
o
Wall terminal has the correct
position and side up;
o
Roof terminal has the correct
position.