Version 07/11 - Page 8
Light On/Off Button ( L )
On/Off switch for the halogen lights. Move the switch to "1" to turn
the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower. Move the switch to "1" to turn the
blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Speed control for blower. Move the switch to position 1 for LOW
Speed, 2 for MEDIUM speed and 3 for HIGH speed.
For Best Results
Start the rangehood several minutes before cooking to develop proper
airflow. Allow the unit to operate for several minutes after cooking is
complete to clear all smoke and odors from the kitchen.
Cleaning
The stainless steel grease filters should be cleaned frequently in hot
detergent solution or washed in the dishwasher. Clean exterior sur-
faces with a commercially available stainless steel cleaner. Abrasives
and scouring agents can scratch stainless steel finishes and should
not be used to clean finished surfaces.
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking vapors
and odors from the cooktop area.
Rangehood Control Panel
The control panel is located on the right-hand side under the canopy.
The position and function of each control button are indicated in
FIGURE 10
.
FIGURE 10
FIGURE 11
Replacing the Halogen Lamp
Before you begin, make sure that the rangehood is turned off and
that the other lamps have had sufficient time to cool. Halogen lamps
burn extremely hot and serious injury could result from touching a
hot lamp. Press and twist the lamp to remove. If this is difficult for
you, you can remove the stainless bezel which is held in place by two
screws
(A in FIGURE 11)
. Remove the two screws and the bezel.
Then remove the lamp and replace with a new lamp. Once the new
lamp is in place, reinstall the bezel.
0 1
0 1
0 1 2
L
M
V
WIRING DIAGRAM
• This rangehood uses 45 watt Halogen Lamps.
