Faber Honest, Installation Manual

Page: 11 / 24

> > > > 10
4.4 Building the surround
The figures shown are indicative for one possibility. There is a lot of freedom to build a
surround around the honest. However always keep in mind:
•
Upside of opening has to be equal with the opening of the appliance (see figure 1.5)
•
Keep at least 10 mm between the appliance and the surround, except at the
underside of the opening where the minimal distance has to be 32 mm. This is
necessary for disassembly of the glass! (see figure 1.4 and 1.6)
•
Keep at least 2 mm distance between the side panel and the appliance
•
Don’t forget to make a door to keep the gas control accessible!
Note: try to place/remove the glass many times during build up!
4.5 Placing the log set
Place the log set according to the figures 2-1 till 2-4. As desired the bottom of the
appliance can be spread over with embers. Never spread the embers over the grid and
along the backside!
4.6 Placing the glass
Note: Use both suction lifters to remove/place the glass.
ƒ Place the suction lifters on the glass (see figure 3-1)
ƒ
Keep the glass tilted backwards for the appliance (see figure 3-2)
ƒ
Move the glass carefully downwards between the appliance and the surround till
the stop bracket (see figure 3-2)
ƒ Move the glass towards the appliance and move simultaneously upwards till the
glass fits in the groove (see figure 3.3)
ƒ
Place the glass against the “glass to metal” seal
ƒ Mount the glass with the metal strips and knurled knobs (figure 3-5)
ƒ Place the glass seal rope. Start in the left or right down corner (see figure 3-5)
ƒ
Place the threshold with the lips over the knurled knobs (see figure 3-6)
Note: Remove every stain and finger print before igniting the appliance.
Removal of the glass happens in reversed order.