Faber Gala opti-myst, Installation Instruction

Page: 17 / 40

L
16 < < < <
2.2 General.
The fireplace produces a flame effect without heating function, so you can enjoy the flame effect
all year long.
The Gala can be used with or without glass and can be build in with one side glass or as see through
appliance.
ATTENTION: When the appliance is used in a room with very little background noise, a noise can
heard which is caused by the movement of the flame effect. This is normal and no reason for
concern.
Only use tap water with a maximum hardness degree of 10°Dh (you can ask your water supplier
about the hardness degree). This is necessary in order to lengthen the lifetime of the smoke unit. In
situations with a higher water hardness, the water should be filtered (for example with a Maxtra
filter).
Do not use a decalcifier when cleaning the appliance, this may shorten the lifetime of the
smoke unit.
2.3 Electrical connection
This appliance should be connected to an earthed wall socket.
Check before you connect the fireplace if the mains voltage corresponds with the information on
the name plate.
2.4 Installation instruction
Carefully unwrap the fireplace, and keep the packaging for future use, for example a removal or
return of the fireplace to the supplier. The remote control, batteries and lights are packed together
with the log set.
Please read the warning labels carefully. For the correct installation measurements, please refer to
the dimensional drawing in figure 1a or 1b, depending on the method of installation. Always ensure
that the fireplace is levelled, and that the glass can be removed.
2.4.1 Removing the glass.
Place the two suction cups on the glass. Lift the glass from the groove, and tilt the lower part of the
glass to the front and downward. Reinstall the glass in reverse order.
2.4.2 Installation of the fireplace with surround.
Put the floor plate on the floor and position the fireplace on the floor plate, ensure that it is
levelled, and screw it to the back wall. Put the power cable in the v-groove of the floor plate.
The Gala is supplied with a MDF drawer, remove this and fit the marble drawer which is supplied
with the surround.