Faber Ease (BF100H), User Manual

Page: 10 / 49

UK/IRL
10 < < < <
If the builders' opening is constructed out of non-combustible composition
board (Fibrelux) and you install the appliance without a mantel then:
•
Ventilate the space above the appliance (min. 1000 mm2 ).
•
Always fit the DC convection set.
•
The plaster of the outside has to be resistant to a high temperature.
Use therefore the plaster materials especially made for this, to
prevent discolouring (min. 100 °C temperature resistant).
•
The plaster has to dry for at least 1 day per millimetre plaster. This
means that 4 mm plaster has to dry for at least 4 days before the
appliance should be used. This is to avoid cracking.
•
If the appliance is to be fitted against a wall with combustible
cladding, the cladding must be removed from the area covered by the
surround.
The minimum height from the top surface of the fire to the underside of
any shelf made from wood or other combustible materials is as follows:
•
For a shelf up to 150 mm deep – Minimum height = 350 mm (fig. 1).
•
If the shelf depth is greater than 150 mm add 50 mm to the upper
clearance height for every 25 mm increase in shelf depth.
•
Side clearance = Minimum distance from the side of the fire frame to
combustible material = 150 mm.
4.2 Flue requirements
•
The appliance is of the type C11/C31. The appliance will need to be
supplied with the approved flue pipes and terminal, it is not possible
to supply your own.
•
The minimum effective height of the flue system must be 0.5 or 1
meter, depending on the appliance.
•
Terminal locations, through the wall as well as through the roof. See
figure 3.
Flue routing;
•
a horizontal extension with elbows is allowed for a maximum of 6
meters (depending on the type and situation).