26
Replacement Part Procedures
Module Power Supply Replacement
Tools Required:
Phillips head screwdriver
1. Follow the Preparing for Service instructions. (Page 11)
2. Remove the access cover screw. (Figure 16)
3. Remove the 4 screws and the electronic cover from the unit. (Figure 16)
4. Remove the 2 screws securing the cable clamp. (Figure 18)
5. Holding the electronics assembly close to the ends of the LED light strip, gently lift the electronics assembly out of
its original position to expose the attached components. (Figure 18)
6. Locate the power supply assembly. (Figure 23)
7. Disconnect the power supply wires from the terminal block and main control board.
!
NOTE:
A flat head screwdriver can be used to gently pry between the end of the connector and the switch to release
the wires.
8. Remove the old power supply from the module and replace with the new power supply.
9. Place the new power supply wires in the terminal block and on the main control board.
10. Reinsert the electronics assembly
CAUTION:
Ensure that the terminal block has not moved from its original location and all wires are contained under the
cover before reassembly.
11. Reinstall the electronics cover and access cover in their original position in the module and secure the 5 screws.
12. Re-assemble the remainder of the components in reverse order from the Preparing for Service instructions. (Page 11)
Power Supply
Figure 23
