Faber e-MatriX heat e-BoX, User Manual

Page: 23 / 56

User manual e-MatriX heat + e-BoX
23 < < < <
General

Please note!
Used in an environment where background
noise is very low, it may be possible to hear a
sound which is related to the operation of the
flame and heat effect. This is normal and
should not be a cause for concern. If this
product experiences a power surge for
whatever reason the product may cut-out.
This is a normal safety feature and the product
will resume operation after 30 seconds.
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the fan
heater to prevent damage due to overheating. This
can happen if the heat outlet was restricted in any
way. If the cut-out operates, unplug the heater
from the socket outlet and allow approximately 10
minutes before reconnecting. Before switching the
heater back on remove any obstruction that may
be restricting the heat outlet, then continue
normal operation.
CAUTION: IN ORDER TO AVOID A HAZARD DUE TO
INADVERTENT RESETTING OF THE THERMAL CUT-
OUT, THIS APPLIANCE MUST NOT BE SUPPLIED
THROUGH AN EXTERNAL SWITCHING DEVICE,
SUCH AS A TIMER, OR CONNECTED TO A SWITCH
THAT IS REGULARLY SWITCHED ON AND OFF BY
THE UTILITY.
Manual control
e-MatriX: button functions Control box (fig. 1.0):
e-BoX: button functions Engine (fig. 1.4):
A = main switch
1 = ON/OFF
2 = pairing
3 = only for maintenance (service engineer)
4 = reduce flame
5 = increase flame
6 = reduce fire crackling sound
7 = increase fire crackling sound

Please note!
Main switch ‘A’ controls the electricity supply
to the fire. To operate the fire, with or without
the heat activated, this switch must be in the
“ON” (I) position.
First time water fill

Ensure that all ball valves are open and
turn on the water supply;

Ensure that the mains switch is in the
“ON” (I) position;

Switch the fire on by pressing the
button. This will be indicated by an
audible “beep”.
o
If the water level is high enough
the flames will automatically
start after 45 seconds.
o
If the water level isn’t high
enough after 45 seconds, fault
code 51 will be displayed:
With the remote control
activated, press
◁
or
▷
button
to highlight “CD51”. Press
✔
to
select. On reset screen, hold
✔
button for 3 seconds to clear the
error. (the fire will come on
automatically).
Switching ON the fire (without heat)
Press the button to turn on the flame effect. This
will be indicated by an audible “beep”. Although the
main lights operate immediately it will take a
further 45 seconds before the flame effect starts.
Switching OFF the fire (standby mode)
Press the button to put the fire into standby
mode. This will be indicated by an audible “beep”.
Remote control
Button functions, see fig. 1.1:
1 = display
2 = menu (home screen)
3 = return
4 = advance
5 = left/right and up/down
6 = confirm

All functions of the fire can be operated
with the remote control.

Due to battery saving, the remote control
screen will turn off after 10 seconds. To
reactivate the remote control, press and
hold the
✔
button for 1 second.

The remote control is already connected
with the receiver, so the fire is ready for
use.
Placing batteries in the remote control

Lift off the battery cover on the back;

Place 2 AA 1.5 Volt Alkaline long life
batteries;

Place the battery cover again.
After replacing the batteries, the Date and Time
need to be set first, see section 5.1.