Faber e-MatriX 800-500 RD, Installation Manual, Page: 10 / 32

Installation manual MatriX 800/500 RD,ST
9 < < < <
ney, a horizontal screen plate, made of non-com-
bustible material, must be installed just above the
ventilation openings. (see A in fig. 1.0 and 1,2).
Installation and finishing

Please note!
• Take into account a minimum distance of
2 mm due to expansion of the fireplace.
•
Take into account the thickness of any fin-
ishing layer!
Method I: installation WITH cover strip
(see F, Fig. 3.0a)
For installation and finishing the following
points are of interest (fig. 3.0b):
G = Build-in frame
H = Spacer profile
•
Build the false chimney against the build-
in frame G and the spacer profile H (Fig.
3.0b).
• Do not build the false chimney (under-
neath the appliance) higher than the top
of the distance profile H.
Method II without cover strip (see Fig. 3.1a)
For installation and finishing the following
points are of interest (fig. 3.1b:
I = Build-in frame
J = Glass support
K = Upper side of combustion chamber
setting
•
Remove all-round spacer profile H
(Fig. 3.0b).

Please note!
Ensure that the screws of the spacer profiles H
are replaced to ensure the air tightness of the
device.
•
For the height of the platform, observe
point K (Fig. 3.1b).
•
Due to the expansion of the fireplace,
there should be at least 2mm play be-
tween the platform and the glass supports
J (Fig. 3.1b).
5 Removing the glass
5.1 MatriX 800/500 RD
Removing the glass from the front
•
Remove cover strip “A” (Fig. 4.0a).

Rotate clamp “B” clockwise (fig. 4.0b).
•
Place the suction cups on the glass and
slide the upper frame “C” upward (fig.
4.0c).
•
See fig. 4.0d:
1. Slide the glass to the top so that the
bottom is released from the slot.
2. Bring the left side slightly towards
you.
3. Slide the glass a little to the left.
4. Pull the glass down and store it at a
safe place.
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
Removing the glass from the side
It is not necessary to take out the glass from the
side to place the wood set or for maintenance.
•
Remove the glass strip at the top (fig.
4.1a).
•
Place the suction cup on the glass (fig.
4.1b).
• See fig. 4.1b:
1. Slide the glass to the top so that the
bottom is released from the slot.
2. Pull the glass down and store it at a
safe place.
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.