1.
Use 5/32” Allen Wrench and 7/16” combination wrench (or socket) to attach 22842 to 22844 and
22843 to 22845. (Figure 1) Repeat this for all four (4) corners. Align three (3) holes and attach using three
(3) ¼” Stainless Steel Cap head bolts, six (6) stainless flat washers, and three (3) stainless nuts per corner.
2.
Thread on one (1) 3/8” stainless nut (50361-HW) onto each of the ten (10) HD adjustable feet
(61807). Then, put one (1) 3/8” flat washer (50361-HW) on each of the feet.
3.
Thread one (1) foot into each of the weld nuts on the bottom of all four corners assemblies.
There will be two (2) or three (3) feet per corner assembly. Set at roughly the same height. These will be
adjusted to final height in a later step.
Assembly
