15
19. Install the OEM license plate lights into
the bumper by putting the face of the light
on the outside and connecting it with the
light and clip from the inside. Apply epoxy
(61632) if needed. (Figure-20)
20. Use a 3/4” socket wrench to install the
two D-ring brackets (21990 and 21991) with
two 1/2” Hex head bolts flat washers and
lock washers (50199-HW). Use a 11/16”
socket wrench with a 7/32” Allen wrench to
install the 7/16” stainless button head bolts
with flat and lock washers and nut (50199-
HW). Fully tighten all bolts. (Figure-21)
Figure 20
Figure 21
21. If truck is not equipped with rear side
sliders, install the side mounting brackets
(21998 and 21999) using two M10-1.5 bolts
with flat and lock washers along with a
7/16”-4” zinc steel hex bolt with flat and
lock washers and nut (50199-HW). Use a
16mm socket wrench to install the M10
hardware and a 11/16” and 5/8” socket
wrenches to install the 7/16” hardware.
(Figure -22)
Figure 22
