16. Use a 3/4” socket wrench to attach the
wings (22000 and 22001) to the bumper
(21989) using the four provided bolt strips
(20296) along with the 1/2” flat and lock
washers, and nuts (50199-HW). Leave nuts
hand tightened at this time for easier install.
(Figure-17)
17. Install the OEM sensor harness into the
bumper and connect the four sensors into
their respective housings by pushing them
into their clips. Make sure the harness plug
is on the passenger side of the bumper.
(Figure-18)
Figure 17
Figure 18
18. Use a pair of scissors or cutting plyers
to remove the tabs on the face of the OEM
license plate lights before install. (Figure-19)
Figure 19
