If you are installing a rear camera, you will need to program MyLink by following
the steps below:
1°. Check if the upper DIP SWITCH 1 is switched up;
2°. Turn the car ignition on and wait for the MyLink to fully start;
3°. Put the car on RECERSE and wait for about 1 minute until the MyLink
program the rear camera and restart automatically.
NOTE: When you put the car on reverse, MyLink will turn off and the rear
camera programming will begin. This process can take up to one minute, and
while it happens the interface’s yellow LED will blink, and icons will show up on
the car’s dashboard.
IMPORTANT NOTICE: The rear camera will only be shown when the car is on
reverse and the motor is running.
The rear camera programming can only be done in one single car. After it has been
done, it won’t program on any other car.
NOTE:
Icons shown during
the rear camera
programming
Icons shown during the rear
camera programming
5
PROGRAMMING THE REAR CAMERA
