Door Controller
18
532226 - Rev. D
2
• DHCP ENABLE
!
The Door Controller goes out of factory configured with active DHCP.
This function is available from the
Door Controller firmware version 01.01.01 K
or higher and
Keydom software 1.1.0
or higher.
With lower Software or Firmware versions see
DHCP DISABLED
section.
If the DHCP service is not available in your network, you must change the configura-
tion of the Door Controller (see chapter Configuration - Function 3).
To configure the IP address, Subnet Mask, Gateway, and the Door Controller
Identification Number, install and power all Door Controllers, access the Key-
dom software in the Configuration - Devices - Device Discovery (follow the
Keydom software manual for use).
Once a fixed IP address is assigned, the DHCP function is automatically disabled.
• IP ADDRESS ASSIGNMENT FOR DOOR CONTROLLER LAN
EN
Translation of the original instructions
• DHCP DISABLED
With DHCP deactivated
(see chapter Configuration - Function 3 Disabling/Enabling DHCP)
,
to modify the parameters, you must use the Door Controller Web Interface by
accessing the IP address configured.
L
L
Default IP address: 192.168.1.240
