pg. 2
Programming
–
The programming function is password (PWD) protected. To select
one of the 12 programming functions, you will need to enter the PWD before
selecting a function. The factory set PWD for the keypad is
1 2 3 4
The procedure to enter programming mode is # PWD # ( # 1234 # )
Store A User Code (1)
–
This stores the user code to be entered to activate the radio
channel. For this example we will setup the code
9 8 7 6
as the activation code to
activate channel
1.
The complete sequence to do this is
-
Enter Programming Mode - ( # 1234 # )
-
Select Programming Function
–
( 1 )
-
Enter Activation Code
–
( # 9876 # 9876 E )
-
Select Channel to Activate
–
( 1 # )
# 1234 # 1 # 9876 # 9876 E 1 #
You have now setup the code 9 8 7 6 E as the
activation code for your gate. After 60 sec the keypad will exit programming mode or
you can press
E
for a quick exit.
Teach the Keypad to a Receiver Card (8)
–
This will allow you to program Channel
1
of the keypad to your receiver card.
(During this process the keypad needs to be at least 30cm away from the receiver)
# 1234 # 8 # 1
( place the receiver into learn mode ) then
press and hold # on the
keypad for 5 seconds
Wait 60 sec until the keypad exits programming mode or you can press
E
for a quick
exit.
The first time you use the keypad you will need to activate the channel. To do this
you need to
–
enter the user code followed by the letter E, wait until green LED turns
off, then press E again.
9876 E
wait for green LED to go out,
E
again.
Your keypad is now setup with the code 9876 E, this will activate the gate using
channel 1 on the keypad.
