1) ATTENTION! To ensure the safety of people, it is
important that you read all the following instruc-
tions. Incorrect installation or incorrect use of the
product could cause serious harm to people.
2) Carefully read the instructions before beginning
to install the product.
3) Do not leave packing materials (plastic, poly-
styrene, etc.) within reach of children as such
materials are potential sources of danger.
4) Store these instructions for future reference.
5) This product was designed and built strictly for the
use indicated in this documentation. Any other use,
not expressly indicated here, could compromise
the good condition/operation of the product and/
or be a source of danger.
6) FAAC declines all liability caused by improper use
or use other than that for which the automated
system was intended.
7) Do not install the equipment in an explosive at-
mosphere: the presence of inflammable gas or
fumes is a serious danger to safety.
8) The mechanical parts must conform to the provi-
sions of Standards EN 12604 and EN 12605.
For non-EU countries, to obtain an adequate level
of safety, the Standards mentioned above must be
observed, in addition to national legal regulations.
9) FAAC is not responsible for failure to observe Good
Technique in the construction of the closing ele-
ments to be motorised, or for any deformation that
may occur during use.
10) The installation must conform to Standards EN 12453
and EN 12445.
For non-EU countries, to obtain an adequate level
of safety, the Standards mentioned above must be
observed, in addition to national legal regulations.
11) Before attempting any job on the system, cut out
electrical power.
12) The mains power supply of the automated system
must be fitted with an all-pole switch with con-
tact opening distance of 3 mm or greater. Use of
a 6A thermal breaker with all-pole circuit break is
recommended.
13) Make sure that a differential switch with threshold
of 0.03 A is fitted upstream of the system.
14) Make sure that the earthing system is perfectly
constructed and connect metal parts of the
closure to it.
15) The automated system is supplied with an intrinsic
anti-crushing safety device consisting of a torque
control. Nevertheless, its tripping threshold must be
checked as specified in the Standards indicated
at point 10.
16) The safety devices (EN 12978 standard) protect
any danger areas against
mechanical movement
Risks
, such as crushing, dragging, and shearing.
17) Use of at least one indicator-light (e.g. FAACLIGHT
) is recommended for every system, as well as a
warning sign adequately secured to the frame
structure, in addition to the devices mentioned
at point “16”.
18) FAAC declines all liability as concerns safety and
efficient operation of the automated system, if
system components not produced by FAAC are
used.
19) For maintenance, strictly use original parts by
FAAC.
20) Do not in any way modify the components of the
automated system.
21) The installer shall supply all information concern-
ing manual operation of the system in case of an
emergency and shall hand over to the user the
warnings handbook supplied with the product.
22) Do not allow children or adults to stay near the
product while it is operating.
23) Keep remote controls or other pulse generators
away from children, to prevent the automated
system from being activated involuntarily.
24) Transit is permitted only when the automated
system is idle.
25) The user must not attempt any kind of repair or
direct action whatever and contact qualified
personnel only.
26) Check at least every 6 months the efficiency of
the system, particularly the efficiency of the safety
devices (including, where foreseen, the operator
thrust force) and of the release devices.
27) Anything not expressly specified in these instruc-
tions is not permitted.
WARNINGS FOR THE INSTALLER
GENERAL SAFETY OBLIGATIONS
Summary of Contents for C720
Page 1: ...C720 C721 C720 C721...
