950N 12
732708
- Rev. C
950 MPS
EN
G
L
ISH
6
PROGRAMMING THE 950 MPS BOARD
DS1 950 MPS SETTING
N°
FUNCTION
OFF
ON
NOTE
1
Final closing stroke
Disabled
Enabled
When the door is in “closed”
position, allows enabling of a
further
inal closing stroke. (Useful with
electric locks)
2
Set-up procedure
Articulated arm and/
or openings up
to 90°
Sliding arm and/
or openings
greater than 90°
3
External selector switch in
position 2
Position 2
set on
Manual
Position 2
set on
Night
Allows to decide which mode is to
be associated to position 2 of the
external selector switch
4
Push and go
Disabled
Enabled
By setting the external selector
switch to 0 (automatic), if the door
is pushed or pulled in opening
direction, it will open.
5
Leaf delay at opening
(master/slave application)
Disabled
Enabled
6
Not used
7
STOP safety detection
space
(Terminal 14
950 I/O board)
Active during the
entire stroke
Active up to 70°
opening of the
door
If set to ON, the STOP safety is
monitored by a sensor installed on
the door and avoids the detection
of any obstacles beyond 70°
opening (e.g. side wall).
8
SCP
(Selectable Close Powe-
ring)
Additional force before
closing
Disabled
Enabled
When this function is enabled, it
reduces the sensitivity of the
electronic anti-crushing device.
The activation of this function is
useful whenever high friction,
particularly hard door gaskets or
electric locks with dificult latching
are present.
9
Not used
10
Board updating using the
RS232 port
Disabled
Enabled
Allows enabling of the RS232
port for connection with the PC to
perform irmware updates.
Fig.4
Summary of Contents for 950N
Page 1: ...950 N...
