FAAC 844, Installation Manual, Page: 16 / 23

16
1
Brake adjustment: Turn the potentiometer
counterclock-wise to decrease the braking force and
clockwise to increase the braking force.
2 Reset
3 Fuse F2, 1.6 A, for the power supply to accessories
4
Fuse F3, 250 mA, for the transformer
5
Fuse F1, 5 A, for the electric motor
6 Terminal block J7 for connecting a flashing warning
light (maximum load of 60 W)
7
Terminal block J8 for connecting the power supply to
the 844 operator
8
Terminal block J6 where the 35
µ
F capacitor is
connected
9
Terminal block J5 where the motor is connected
10 Terminal block J4 for right-closing limit switch
connection
11 Terminal block J3 for left-closing limit switch
connection
12 Jumper: do NOT cut or remove
13 Terminal block J2 for low-voltage accessories
14
Light-emitting diodes (LEDs) for signalling gate status
15
Connector for MD01 board
16 DIP switch assembly
Figure 16. The 844 MPS Control Panel
FAAC
MINILAMP
POWER
SUPPLY
CO
MMO
N
CO
MMO
N
CO
MMO
N
OPEN
STOP
FSW
COMMON
COMMON
COMMON
Figure 17. The 844 MPS terminal strip. See Figure 13 for the connection of the limit switch ribbon
cable appropriate to your gate design.
Upswung.com