10
11
746 E R
15
732099 - Rev.D
~ 15 cm
19
70
Tr
ansla
tion of the original instruc
tions
ENGLISH
5. MECHANICAL INSTALLATION
6
Symbols: tools
7, 10, 13, 19
Spanner
3
Hex key
5, 6.5
Drill bit for metal
M8
Threading tap
(for screw-on steel rack)
Level
Angle grinder
Wire strippers
Electrician's scissors
Screw clamp
Welder
(for weld-on steel rack)
2.5, 6
Flat-head screwdriver
3, 8
PHILLIPS SCREWDRIVERS
x.x Nm
TORQUE WRENCH - if necessary for safety, a torque wrench and the TIGHTENING TORQUE will be specified
E.g.: SPANNER 7 set at 2.5 Nm
7
2.5 Nm
5.1 INSTALLING THE FOUNDATION PLATE
RISKS
PERSONAL PROTECTIVE EQUIPMENT
F
Carry out the work with the power supply disconnected.
!
- The 746 E R must be installed with the foundation plate.
- The characteristics of the foundation, indicated in the schematic diagram in
the appendix to this manual, are provided as a guideline only. The schematic
considers the 746 E R applied within the maximum limits indicated in this
manual and under the most arduous conditions. The installer is responsible
for the evaluation of the foundation materials and dimensions on the basis of
the characteristics of the ground and place of installation. Perform structural
calculations where necessary.
1. Assemble the foundation plate (
10
).
2. Make the hole in the ground. Fill it with concrete, making sure that
the cable conduits protrude in the correct position with respect
to the gearmotor. Place the plate at the centre of the foundation,
leaving its surface uncovered (
11
).
3. Clean any concrete from the surface of the plate and the nuts with
washers so that they can be subsequently adjusted. Check the
plate is horizontal using a spirit level.
4. Wait for the concrete to set.
mechanical release side
pinion side
!
The installation must comply with standard EN 12453. Mark off the work
site and prohibit access/transit.
Installation must be carried out when it is not raining. In case of rain, a
suitable shelter for the gearmotor must be provided until the mechanical and
electronic installation has been completed.
Never handle the gearmotor by the electronic board.
TOOLS REQUIRED
The tools required are indicated below (
6
).
!
Use appropriate tools and equipment in working environments which comply
with applicable legislation.
Summary of Contents for 746 E R Z16
Page 1: ...746 E R Z16 746 E R Z20 Translation of the original instructions...
Page 41: ...746 E R 41 732099 Rev D...
Page 42: ...746 E R 42 732099 Rev D...
Page 43: ......
