F5 i10000 Series, Platform Manual

Page: 36 / 72

5. Inspect the new PSU, especially the connector area, for any damage that might have occurred during
shipment.
6. Slide the new PSU into the empty slot, and push it in until the ejector latch engages and clicks.
Note: While installing the supply, use care to ensure that the supply's connector does not come into
contact with the rear of the chassis.
7. Ensure that the PSU is fully seated in the chassis by making sure it does not come out when gently
pulled.
8. Connect an auto locking AC power cord to the power input panel on the new PSU.
Note: Be sure to route the power cords away from the fan tray so that the cords do not impede access
to it.
9. Connect the power cord to the power source.
If the system does not boot after you apply power to the PSU, use the touchscreen LCD to power on
the system.
10. (Optional) Use the LCD touchscreen to clear any alert messages that might have resulted from
performing the PSU replacement.
Replace an AC power supply in a dual-supply system
In the event of a power supply unit (PSU) failure, you can replace an AC PSU in a dual-supply system
without powering down the system, provided that there is at least one PSU operating during the
replacement process.
Caution: Be sure that you are using the correct wattage power supply when performing a power supply
replacement.
Note: All photos shown are examples. The appearance of your components or accessories might vary
slightly.
Platform Maintenance
36