TRT800H / P/N 800ATC-H-(2xx)-(26x)
Operation and Installation
31
Document-No: 03.2126.010.71e / Revision: 2.00
Page 5
Altitude correction settings
(part 2)
Note
1
: Position data will only be displayed if
•
a GPS protocol is set (NMEA / FREEFLIGHT / …)
•
GPS receiver is connected and transmits data (if not: “Pos. :no
data” is displayed)
•
a valid position is transmitted (if not: “Pos. :wrong data” is
displayed).
While configuration summary page is displayed no new position data will
be processed.
4.3 General settings
4.3.1 ICAO 24-Bit Aircraft Address (AA)
Ask your national aviation authority (e. g. in Germany: LBA, Referat B5,
Department “Verkehrszulassung”) how to obtain the AA. In the case of
aerial sports equipment the contact point would be the respective
associations.
Only the assigned AA has to be used and must not be modified at any
time, because a duplicate address would jeopardize the data
surveillance and integrity figures of Mode S.
If no AA is stored, after power on the display shows
“CRADLE OFF” and the transponder operates in Mode A/C.
(Configuration of the AA: see section 4.5.4)
18000 ft: 0ft
25000 ft: + 100ft
35000 ft: - 50ft
exit
Setup
→
4.5.4