F.u.n.k.e. FSG 90, Installation & Operation Manual

Page: 54 / 81

FSG 90 System
5 SET-UP Procedure
48
FAV_D10024 December 2014
5.4.14 Reset
CAUTION!
Every RESET to the factory setting

deletes all your pre-set memory channels 5 to 99 (in both
‘8.33/25 kHz’ and ‘25 kHz only’ Mode)! Memory channels 1 - 4
get programmed with 118.00 or 118.005 respectively

deletes your password!

delete all your individual SET-UP adjustments!
To reset all adjustments proceed as follows:

Turn OFF the radio (
ON/OFF-VOL
knob fully ccw).

PUSH AND HOLD simultaneously the buttons
MD
,
STO
and
SQ
, then turn ON
the radio (rotate
ON/OFF-VOL
knob clockwise, approximately mid position).

All segments of the display appear for a short moment then the display gets blank.

Release the buttons.
After releasing the three buttons the display shows in the upper line
alternately
»SET« and »RESET« , in the lower line »0« .
If there is no activity for 60 seconds the radio will return to the mode
used before.
With the
F/CH
knob set lower line to " 1 ".
Confirm RESET by pushing the
STO
button.
The upper segment of the On-board Supply Indicator will light up
shortly.

The VHF radio
FSG 90(X)
is now operable in the factory setting.