Ezytrail WINTON 10, Owner'S Handbook Manual

Page: 49 / 53

Set-Up
Slide the awning keder beading, on the rear of the awning roof (see Diagram 1), through the awning
channel until it is in your required position (see Diagram 2).
Locate the deflation valves at the bottom of each of the AirPoles (3). Ensure that the deflation valves are
closed by turning the tap clockwise 90° (see Diagram 3).
Locate the inflation valve on the awning (4). Unscrew the top cap and attach the pump nozzle (5). Start to
pump (6).
Once the awning has a good amount of air in it, pull the front of the awning outwards so that the AirPoles
can assume their correct shape (7).
Pegging Point A: Peg the corners of the awning (8a). Each corner should be pegged vertically in-line with
the top of the canopy, at an equal distance away from the vehicle and in-line with each other.
Pegging point B: Loosen the quick pitch straps and peg them out diagonally from the corners (9b). Tighten
the quick pitch straps once in position (10b).
Clip the storm straps into place (11c) and hook the pegging “O” ring onto the bottom of the strap (12d) and
peg. Keep pumping until the ideal inflation pressure of 9 psi (0.62 BAR) is achieved. If necessary take a rest
before adding more pressure.
Optional Side Wall Set-Up
Push the open ends of the pole onto the connection points inside the front and rear corners of the awning
(13ef).
Clip the hooks at the top of the side wall fabric to the long pole (14).
Use the locking mechanism (15) once in place to stabilise the pole and help keep side walls taut.
Attach the ladder pegging straps to the anchor points located at the bottom of the side walls, then peg
(16g).
50