Ezytrail WINTON 10, Owner'S Handbook Manual

Page: 26 / 53

PROBLEM POSSIBLE CAUSE SOLUTION
No 12V Power
Main Power Switch “OFF” Turn on Main Power Switch
Battery isolator switch off Turn on
Main circuit breaker tripped Reset main circuit breaker
Loose battery connections Tighten terminals and connections
Damaged wiring Find damage and repair/replace
Flat battery Charge battery
Battery not charging
Charger turned off Turn charger on
No mains power Indicated by charger not turning on. Check mains power, if
charge still doesn’t switch on, the charger may be faulty.
Contact dealer for warranty or replacement.
Tripped circuit breaker Reset breaker
Charger overheated Rest for 30 minutes and try again. Ensure adequate
ventilation around charger and allow to cool. Do not store
items around electronics.
Faulty charger A charger fault will be indicated by fast flashing on the
charger control panel. Contact dealer for warranty or
replacement.
Faulty battery Have battery tested and replaced if faulty
Lights or plugs not
working
Tripped circuit breaker 2 Reset breaker
Poor connection 3 Find and rectify
Circuit switch “OFF” 1 Check control panel and switch to “ON”
No power to fridge
Tripped circuit breaker Reset breaker
Poor connection Find and rectify
Circuit switch “OFF” 1 Check control panel and switch to “ON”
Indicators or park lights
not working
Poor connections at trailer plug Check and clean plug contacts. If pins are closed, use a knife
or small screwdriver to separate the spit in pin slightly. This
gap should be even along length of pin.
Damaged Chassis wiring Check and repair as required
Inverter not powering
Poor connection 2 Check 12V connections are tight
Power switch is “OFF” 1 Turn on Main Power Switch
Flat battery 4 Charge battery
Inverter Fault Protection Indicator ON 3 Refer to User Manual
Circuit breaker tripping
during use
Overloading Check amperage draw from appliance
Faulty appliance Check appliance and rectify
WATER
PROBLEM POSSIBLE CAUSE SOLUTION
Pump not working (no noise)
No power from control panel Check circuit switch and circuit breaker
Faulty pressure switch Replace pump, Contact dealer for replacement
Bad electrical connection Check connections with multimeter or test light
Flat Battery Charge battery
Pump working but no water flow
Airlock in water lines Turn on tap and hold finger over nozzle for 5 seconds
and release. Repeat several times. If this fails, fill
water tank and use mains pressure to pressurize
tank
Water tank is empty Fill water tank
Kinked hose Check hoses ensuring none are fouled
Damaged / worn pump diaphragm Repair or replace pump
GAS
PROBLEM POSSIBLE CAUSE SOLUTION
Cooker not igniting
Gas will not ignite Replace PIEZO Battery
Gas bottle empty Fill gas bottle
Gas bottle not turned on Turn on valve on gas bottle
Gas hose on cooker not connected Check bayonet is securely connected into receiver
Stove dirty Clean stove of grease/dirt buildup
Kinked hose Check hose is not twisted and kinked
Regulator blocked - Get professional diagnosis and help
* Remember that first use after connecting/reconnecting gas may take up to 2 minutes for the gas to purge the line to the
cooktop. Once ignited hold the control knob down for up to 5 seconds.
TROUBLE SHOOTING
HOT WATER
PROBLEM POSSIBLE CAUSE SOLUTION
No Hot Water
Gas will not ignite Refer to owners manual
240V not connected Connect and turn on as required
www.ezytrail.com.au 2 7