ezWAVE Access Point Users’ Guide
Version 1.11
Copyright© Widelink 2000
DOC – 2001.02.01
Page 35 of 64
Set Bits per second (baud rate) to
19200
, Data bits to
8
, Parity to
None
, Stop bits to
1
,
and Flow control to
None
. And then click
OK
.
The Setup screen appears in the HyperTerminal window. If the text does not appear
immediately, press
Enter
.
If it is successfully connected to Access Point, it will display the following window (figure
shown bellow). During the installation if a password command appears just type
“
public
”:
Type
disconfig
and press
Enter
to see the current default settings of the Access Point.
Make a note of the SSID, Channel number and IP address. Widelink’s Access Point has
a default IP of
100.100.100.100
.
The other options that are displayed can be ignored in this chapter and there will
be detailed explanation on next Access Point Management section.