eZi-DA66 Installation Manual
Revision 1.2
Page 13
CONNECTING SOURCES
The Multizone Controller provides 6 x stereo unbalanced line level source inputs which can be accessed by any zone. Input 1 can be used as a paging (all
zones) input or a party mode (all zones) input. When a source is connected to input 1 and 12VDC is applied to the PA-IN jack (3.5mm tip+ sleeve -), source 1
will be broadcast in all zones. If there is no DC voltage applied to the PA-IN jack then source 1 will act like all the other 5 sources and broadcast only when a
zone selects source 1. Always use good quality shielded RCA cables to connect sources to the Multizone Controller and keep RCA cables as short as possible
to avoid RF interference.
INFRARED EMITTER OUTPUTS
This system has the ability to repeat IR signals from each speaker zone to control the source devices. The IR signal from the Master Controller to the
source device requires IR emitters (not included) connected to the Master Controller via a 3.5mm TS plug. The IR repeater function supports single-band IR
signals in the 38KHz range only. To install an IR emitter, insert the 3.5mm plug for the emitter into the appropriate IR emitter jack. Position the emitter
bulb so that it is within range and has a clear line-of-sight to the source device(s). If the emitter cord is not long enough, you can use any 3.5mm TS or TRS
extension cable to extend its reach.