5
Autofill Controls
Bathtub Filling
Start the automatic bathtub filling process by
pressing the “bathtub filling symbol” (4) to the left
of the thermostat (2). The green light (30) will be
lit and water will fill the bathtub.
The red “running water” light (31) to the right of
the thermometer indicates that the thermometer
shows the filling water temperature and can be
adjusted by turning the thermostat knob (2).
When the water level reaches the “waterline” inside
the bathtub, (about 53 gallons, 200 liters) the
bathtub filling will automatically stop and both the
green (30) and the red light (31) will switch off.
The light (33) automatically indicates that
the thermometer shows the still bathtub water
temperature.
More water can be added into the bathtub. When
pressing the “bathtub filling symbol” (4) once more,
the green light (30) will flash and water will be
added for approximately one minute.
This procedure can be repeated or stopped by
pressing the “bathtub filling symbol” (4).
WARNING: Always physically check water
temperature before and during bathing/showering
to ensure that the thermoscopic mixer (2) is
functioning.
Showering
Remove the shower handle (11) from the panel and
hold it over the bathtub away from the patient.
Press the “shower handle symbol” (9) to the right of
the thermostat. The green light (32) will illuminate
and water will spray from the shower handle.
The red “running water” light (31) to the right of
the thermometer indicates that the thermometer
shows the running shower water temperature and
can be adjusted by turning the thermostat knob.
Stop the water flow by pressing the “shower handle
symbol” (9) once. Both the green (32) and the red
(31) lights will switch off. The procedure can be
repeated.
The shower water flow is preset when installing the
bathtub. If other shower flows are required, set the
water flow by adjusting the black ball valve inside
the panel.
Whirlpool
To start the whirlpool system, press the whirlpool
symbol (20) and the green light (34) will be lit.
To stop the whirlpool system, press the whirlpool
symbol (20) and the green light (34) will switch off.
Important: Never start the whirlpool when the
water level is below the jet (21). Read separate
whirlpool instructions.
Summary of Contents for EZ 900 Series
Page 19: ...19 Wiring Diagram...
Page 20: ...Wiring Diagram 20...