13
Cleaning the Adjustable Whirlpool Jet (21)
Cleaning the jet: Turn the “jet friction housing”
counter clockwise 90° and pull it out. Clean the jet
and the housing.
Cleaning the valve housing: Remove by lifting the
two hooks (inside the housing) and pull it out.
Cleaning the valve (inside): Turn it counter-
clockwise and pull out.
Cleaning the Screen (23)
Remove the whirlpool inlet safety screen by turning
it counter clockwise.
WARNING: Avoid shin or eye contact with
detergent, which is highly corrosive. If contact
is made, rinse immediately with excess water. If
irritation occurs, consult a medical doctor. Always
read and follow label directions carefully.
Routine Maintenance
Daily Maintenance
•
Clean the tub after every use.
•
Check the cleaning supply at least daily,
depending on the frequency of use.
•
Avoid abrasive cleaners which may scratch the gel
coat finish of the fiberglass bathtub and the panel.
•
When the tub is not in use, lower it to its lowest
position and make sure all valves are closed.
•
Clean the strainers on the patient and cleaning
shower handles by rubbing it with your thumb.
•
Visually inspect the tub interior to make sure
there are no nicks or cracks which may scratch the
patient.
Please note: Iodine, bromine, and methylene blue
can discolor the fiberglass.
The recommended frequency of these maintenance
procedures will depend on the hardness of your
water supply and how often the equipment is used. It
is good practice to establish these routine procedures
on a weekly basis and then adjust the frequency as
your conditions indicate.
All mechanical parts inside the bathtub panel are
maintenance free.
WARNING: The equipment must not be used
in any way that varies from the safety precautions
and operating procedures detailed in this manual.
The equipment must not be operated by anyone
until the user has read and understands the
operating manual.
Summary of Contents for EZ 900 Series
Page 19: ...19 Wiring Diagram...
Page 20: ...Wiring Diagram 20...