8
Operating Instructions
•
To start the music, press button (1). Press button
(2) if you want to turn the music off.
•
The volume can be turned up and down with the
buttons (3) and (4). Press and hold button (3) for
a few seconds to increase the volume and button
(4) to decrease it.
•
Switch between tracks by briefly pressing button
(3 - next track) and (4 - previous track).
General Information
The control box for the MP3 sound system is
attached at the bottom of the tub. MMC-, as well as
SD memory cards up to 1 GB can be used. (Please
adhere to the general copyright regulations of the
music played).
NOTE: - ALWAYS SWITCH OFF THE MAINS
BEFORE CHANGING THE SD CARD.
To change/remove the SD memory card, move the
bathtub into its highest position for better access
to the control box. The memory card can be pulled
from the card slot (1) after the control box lid
has been removed. Now you can save the music
you would like to listen to onto the memory card
(observe copyright).
The memory card supplied contains a control
file CONFIG.TXT. This file must not be deleted
because it is necessary for the MP3 player to
function properly.
The music saved on the card must be in MP3 format
and must not be saved in sub-folders/directories
because the player will not recognize them and will
therefore not play them. After saving the music
onto the memory card, place it back into the card
slot (1) and put the lid to the control box back on.
The MP3 sound system is ready for use after the
bathtub mains has been switched on again.
Autofill (Option)
The Autofill allows staff to transfer and prepare the
patient for bathing while the tub is pre-filled.
General Information
The touch control for the Autofill is located on rear
rim.
Operation/Handling
(1) Bath filling
(2) Handshower
Bath filling:
•
Press the bath filling symbol (1) and set the
thermostat to required temperature. Test the
water temperature with your hand or with a bath
thermometer.
•
The solenoid valves open and the tub will be
prefilled with water up to the lower level sensor.
In the meantime, the patient can be transferred
to the bath. The bath is now ready for the patient
to be positioned in the tub. When the patient
wants or requires more bathing water, press the
bath filling symbol (1) once more. The filling will
stop when the water level reaches the second level
sensor (just below overflow drainage).
•
The Autofilling can be stopped at any time by
pressing the bath filling symbol (1).
Handshower:
•
Press the handshower symbol (2).
•
Water will run from mixer faucet into tub. Pull
the diverter knob on faucet to activate the
handshower. To turn off the shower, press the
handshower symbol (2).
Note:
•
Always use symbol 1 for tub filling and symbol 2
for shower.
•
Always check the water temperature with a
thermometer or physically by hand.
•
Never leave the patient unattended during the
entire bathing cycle.
Figure 7 - MP3 Memory Card
1
Figure 8 - Autofill Controls
1
2
