EZ outboard EZ-05T/R, User Manual

Page: 19 / 22

All rights reserved Golden Motor Technology Co., Ltd. 2018
16
16
4.3 Removing propeller
4.31 Spline models
1. Straighten the cotter pin and pull it out
using
a pair of pliers.
2. Remove the propeller nut, washer, and
spacer(if equipped).
WARNING!
Do not use
your hand to hold the propeller when
loosening the propeller nut.
1. Cotter pin
2. Propeller nut
3. Washer
4. Propeller
5. Thrust washer
4.32 Installing propeller
Be sure to use a new cotter pin and bend
the ends over securely. Otherwise the
propeller could come off during operation
and be lost.
1. Apply outboard marine grease or a
corrosion resistant grease to the propeller
shaft.
2. Install the spacer (if equipped), thrust
washer, washer (if equipped), and
propeller on the propeller shaft.
NOTICE: Be sure to install the thrust
washer before installing the propeller,
otherwise the lower case and propeller
boss could be damaged.
3. Install the spacer (if equipped) and the
washer. Tighten the propeller nut to the
specified torque.