Page | 5
5.
BOLT PANEL FRAME TO BASE
5.1.
Using 2-each 5/16"-18 X 1" hex bolts, 4-each flat washers (1 under each bolt and one under each nut), and
2-each nylon insert locknuts, bolt the panel frame to either a single or quad base (FIG. 5.1).
5.1.1.
Single and quad bases have a series of adjustability holes to accommodate portable partition
heights of 4’, 5’, 6’, and 7’. Ensure that the proper holes are used to attain the desired heigh
t.
Always have 2 panel frame to base connection points per side.
5.2.
If adding a second single or quad base, repeat the steps above for the other base. If adding a wall bracket,
proceed to
‘SECTION
6
’
.
Panel frames bolt to wall brackets and single and quad bases in the same manner.
5.3.
Anchor base plates (s
ee ‘SECTION 10’ for anchoring instructions
).
Failure to anchor base plates immediately after assembly could result in a hazardous situation.
Securely anchor the base plates and keep anchored during use. Misused or unanchored partition
can fall over and cause serious injury or death.
FIG. 5.1
Summary of Contents for Portable Partition
Page 7: ...Page 7 FIG 6 3 FIG 6 4 ...
