Fitting the battery
- Remove the screws from the battery cover with a screwdriver.
- Remove the battery cover.
- Insert the 3 Volt CR 2450 lithium battery as indicated under the battery holder (See diagram 2).
- A beep sound is emitted indicating that the battery was properly inserted. If you do not hear any
beep sound after inserting the battery, immediately remove it from the battery holder by using
the supplied magnet (magnetic key) or by tapping briefly the case in the palm of your hand.
-
Check the polarity before inserting the battery once again. If you still do not hear any beep
sound, check the operation by switching the collar On and Off.
- Put the battery cover back in place taking care to insert first the little pin at the bottom of the
battery cover (See diagram 3).
- Retighten moderately the 2 screws.
Fitting the strap
- glide the strap alongside the case (See diagram 4)
- place the slide buckle on the strap
- attach the quick-snap buckle to the free edge of the strap
Description of the product
Diagram 2
« + » terminal
of the battery
downward
Diagram 3
Put the battery
cover back in
place taking care
to insert first the
little pin at the
bottom of the
battery cover
Sensor
(short or long)
White mark:
Area where the magnet is located to
switch On/Off or change mode
Diagram 1
Nylon strap
Switching On the collar
Briefly place (for less than 1 second) the magnetic key close to the white mark located in front
of the collar.
1, 2 or 3 short beep sounds are emitted (according to the chosen mode) and indicate that the
collar has been switched on.
In the factory, the collar’s mode is positioned on mode 3 (ultra vibrations).
Switching Off the collar
Briefly place (for less than 1 second) the magnetic key close to the white mark located in front
of the collar.
1 long beep sound indicates that the collar has been switched off.
Changing modes
In the factory, the collar’s mode is positioned on mode 3 (ultra vibrations).
To change the collar’s mode, when switching on the collar you need to approach and keep the
magnetic key in contact with the white mark.
A series of beep sounds is emitted (from 1 to 3 beeps) indicating the selected mode.
Keep the magnetic key in contact with the white mark to run through modes.
Remove the magnetic key when you have reached the mode you wish.
The collar will memorize your selected mode.
Next time you will switch on the collar, your collar will be turned on to the last mode you
previously selected.
Diagram 4
