Gb - 14
Number of beep sounds heard when
switching modes
Mode
Operation
1
1
ultrasounds only
2
2
vibrations only
3
3
ultra vibrations
Setting the barking detection sensitivity
Setting the barking detection sensitivity ensures detection of any barking but helps avoid
unnecessary detection. The detection, must therefore be sufficiently sensitive but not overly
sensitive. In factory, barking detection sensitivity is set on the maximum position (maximum
sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as
follows:
- Remove the 2 screws from the battery cover with a screwdriver.
- Remove the battery cover.
- Carefully turn the setting screw according to the sensitivity you wish (See. Diagram 5)
Caution: the adjustment system has a stop for the minimum sensitivity and a stop for the
maximum sensitivity. Turn delicately and without forcing with the supplied screwdriver.
- Put the battery cover back in place taking care to insert first the little pin at the bottom of the
battery cover (See diagram 3).
- Retighten moderately the 2 screws.
Checking/ Replacing battery
When the battery is too weak for the operation of the product, beep sounds indicate it in 2 cases:
- When switching On the collar: a series of close beep sounds + number of beeps meant to
indicate the operating mode are emitted
- When switching Off the collar: a series of close beep sounds is emitted
When the battery is too weak, the product works under safety mode, which means that it is out
of use.
Due to greater use during your dog’s training, your first battery may not last as long as
replacement batteries.
Replace the old battery with a new one as follows:
- Remove the 2 screws from the battery cover using a screwdriver.
- Remove the battery cover.
- Knock out the dry battery by using the supplied magnet (magnetic key) or by tapping briefly
the case in the palm of your hand.
- Insert the new battery (See § Fitting the battery).
Changing the sensor
Two different length sensors are included in the package. The size should be long enough to
have proper contact with the dog’s skin, enabling the device to operate correctly.
If you have a long haired dog and the short sensor fitted to the collar in the factory is inadequate,
remove the short sensor and replace it with the long one supplied with the kit.
When changing the sensor, do not press on the threaded rod, it could damage the components
underneath. A moderate manual screwing is sufficient (do not use any key). If you screw the
sensor too much, bark detection is likely to be inefficient.
Fitting the collar
The strap should be adjusted so that the sensor comes right into contact with the dog’s skin in
order to ensure good barking detection.
- If the strap is too loose, the collar will not operate properly. Moreover, it might move around
the dog’s neck and repeated rubbing of the sensor on the skin can cause irritation.
- If the strap is too tight, the dog will have difficulties in breathing.
Do not leave the collar more than 8 hours a day around your dog’s neck and take the time to
check that there are no signs of irritation when your dog is not wearing it. If this happens,
remove the collar until all signs of skin irritation have disappeared.
