Page 13
eyeheight
Unit 34 Park House Watford Business Park Greenhill Crescent Watford Herts GB WD18 8PH
Reg. No. 2855535 Telephone: +44 (0) 1923 256 000 Fax: +44 (0) 1923 256 100 email: [email protected]
Technical Specification for the PM-2E/PM-4
Number of Inputs
1
Type of Inputs
270Mbit Serial Digital Video Inputs 75 Ohm
Line Length
At least 200 Meters of PSF1/3 (Typically 275 Meters)
Number of Outputs
3 Output BNC’s per Card (Configurable).
Type Of Outputs
270Mbit Serial Digital Video Outputs, 75 Ohm, 800mV
Total
Number
Of
BNC Connections
5, consisting of 1 Fixed Input and 3 Jumper
Configurable outputs. (One BNC not used)
SDI Output Jitter
The system will add less than 0.2UI to the input Jitter.
(This is only guaranteed on issue 2 or later cards)
Current Consumption <800mA at +5V
Size
215mm by 100mm
Jumpering the I-BUS (CAN-BUS) Termination
The I-BUS Network is the "control system" under which all Products and
Panels are networked together. Under certain circumstances it is necessary to
terminate the network. This can be done on a Panel or a "Product". To
terminate this product, locate J5 on the PM-2E/PM-4 Processor Card supplied
which is between U1 (The large square "chip") and the Edge connector. (This
is on the half of the card labelled "CHP-100 Spartan2 Processor"). Jumper
this with a 2mm link.
Figure 5 Location of I-bus termination link
Technical Appendix
4