Highway Safety Group Page 8
Version 2014.07.21
V. Installation
To install on the dashboard:
Clean the mounting surface in your vehicle. The EA410 has a metal
base that can be either attached with double-sided tape or metal
screws. Make sure the EyeAlert can still pivot on the mounting base.
To connect power:
The cable has wires for Battery power, Ground and Data. The power
signal should be off when the vehicle is off. The Data wires can be
either connected to an AVL or other data system. The data signals are
3.3 volt logic.
Operation:
The EA410 will begin to work after being powered on, now you can
adjust the position according to the state of the green light facing you.
After the green light is on, move your face around a small amount, if
the green light stays on, that means the installation is good.
The angle between the driver and the camera should be less than 20
degrees.
